Hot Spring Moto-Jet Assembly Kit, white

Out of stock
Add to Wish List
Out of stock

Hot Spring 73307 Moto-Jet Assembly Kit, Warm Grey
Hot Spring 73307 Moto-Jet Assembly Kit, Warm Grey


Use 073307 Warm Grey Kit

Hot Spring 73307 Moto-Jet Assembly Kit in Warm Grey is for the following models: 

Make Model Date Range
Hot Spot SX Current




Item Description Part Number
1a Facia Plate Moto White 36079
1b Facia Plate Moto C Grey 36511
1c Facia Plate Moto W Grey 73305
2 Screw 16x3 34366
3a Screw Cover Moto White 36144
3b Scrrew Cover Moto c grey 36510
3c Screw Cover Moto w grey 73306
3d Screw Cover Taupe 71896
4a Moto Jet Assembly white 70319
4b Moto Jet Assembly c grey 71262
4c Moto Jet Assembly w grey 73307
4d Moto Jet Assembly Taupe 71897
5 Air Tube with o oring 70307
6 Abraision cap (air tube) 30723
7 O ring moto air tube 33020
8a Extrusion shim MM Short 36143
8b Extrusion shim MM Long 36557
* Check Valve 38390

* Non Illustrated Part

  1. Open or remove the spa cover.
  2. Using a standard blade screwdriver, remove the three faceplate screw covers.
  3. Remove the three screws securing the Moto Massage faceplate to the spa.
  4. Remove the Moto Massage faceplate.
  5. Reach into the jet recess and locate the air tube. Gently remove this tube from the barbed nipple at the back of the recess.
  6. Grasping the base of the Moto Massage (end closest to the rear of the jet recess) gently turn the entire assembly counterclockwise until it can be removed.
  7. To reinstall the Moto Massage, reverse steps 1 to 6.

Important Instructions Regarding Moto Massage Alignment:

In order the for the Moto Massage to operate properly it is imperative that the Moto Massage nozzle be properly positioned after the assembly is tightened in the Moto niche.

To properly align, ensure that the two holes located on the nozzle face are position horizontally and that the Moto assembly travels vertically within the niche.

  • image_video
© 2019 Hot Tub Spa Supplies


eCommerce Design by DotcomWeavers