71363 Adjustable Rotary Jet Face, White

In stock
Add to Wish List
In stock

Add to wishlist
71363 Adjustable Rotary Jet Face, White
71363 Adjustable Rotary Jet Face, White

The adjustable jet is the standard jet contained in the spa. The adjustable jet comes with a standard nozzle that can be adjusted to point in various directions within the spa. If applicable, a rotary jet nozzle may also be used in place of the standard nozzle. The rotary jet divides the water flow into two streams, then spins. The amount of air reaching an individual jet can typically be controlled in two ways. First, the amount of air can be adjusted using the air control valve. The air control valve controls airflow to the corresponding jets. Second, some models come equipped with jets where the amount of air can also be adjusted at the jet itself. To adjust the air at the jets, turn the star portion of the nozzle (on older models), or the face (on newer models) clockwise to increase the air. Turn counter-clockwise to decrease the air.

The intensity of the jets increases when more air is injected into the jet.

71363 Adjustable Rotary Jet Face in White is for the following models:

Make Model Date Range
Hot Spring Grandee 1997-2005
Hot Spring Vanguard 2001-2005
Hot Spring Jetsetter 1997-2005
Hot Spring Prodigy 1997-2005
Hot Spring Sovereign 1997-2005
Hot Spring Classic 1997-2000
Hot Spring Landmark 1997-2003




Item Description part #
1 Kit Wall Fitting 71361
2A Rotary Jet Face White 71363
2B Rotary Jet Face C. Grey 71364
2C Rotary Jet Face W Grey 73301
2D Rotary Jet Face Taupe (use 73301) 73301
2E Rotary Face Esc W grey 73812
2F Rotary Face Esc C Grey 73900
3 Gasket Adj Rotary Jet 36534
4A Rotary Jet White 71619
4B Rotary Jet C Grey 71690
4C Rotary Jet W Grey 73303
4D Rotary Jet Taupe 71880
5A Directional Jet White 71691
5B Directional Jet C Grey 71692
5C Directional Jet W Grey 73304
5D Directional Jet Taupe 71881
6 Wall Fitting Front Adj Jet 35977
7 O ring Front Wall Adj 35988
8 O Ring Adj jet (small) 35986


  1. Open or remove the spa cover.
  2. Remove the jet by grasping the jet faceplate and pulling it away from the spa shell.
  3. With jet in hand, two o-rings should be on the rear portion of the faceplate. If either o-ring is not present, inspect the inside of the front wallfitting and remove the missing o-ring.
  4. To reinstall the jet, reverse steps 1 to 3.
    Important: Make sure that the o-rings are properly seated.
© 2019 Hot Tub Spa Supplies


eCommerce Design by DotcomWeavers