A red front o-ring that is used to compress wall fittings in your Hot Spring hot tub. The o-ring is made out of silicone for durability.
Seal your equipment to prevent water leaks. Compatible with a variety of the 1996 to 2011 Hot Spring Highlife, Hot Spot, Solana, and Tiger River spa models.
*Check specs section for full list of compatible models and years.
Remove the jet by grasping the jet faceplate and pulling it away from the spa shell.
With jet in hand, two o-rings should be on the rear portion of the faceplate. If either o-ring is not present, inspect the inside of the front wallfitting and remove the missing o-ring.
To reinstall the jet, reverse steps 1 to 3. Important: Make sure that the o-rings are properly seated.