73188 Control Panel 2 Pump, No Air

CONTROL BOX REMOVAL AND INSTALLATION:

Removing the Control Panel

1. Turn the power off to the spa.
2. Remove the equipment compartment door.
3. Access the control box.
4. Disconnect the control panel modular connector/ribbon cable in the control box.
On the bartop:
4. Make sure the water line is at least six inches, the bottom of the control panel.
5. Using a thin metal blade, i.e. a putty knife, gently pry around the edges of the panel.
6. Remove the panel, gasket material, silicone, and cable from the opening in the shell.

Installing the New Control Panel

1. Align the panel with the opening and thread the ribbon cable through the opening in the shell and down to the control box.
2. Rest the control panel in the location where it will be installed.
3. Connect the cable into the appropriate receptacle on the circuit board; refer to the Electrical Schematic.
4. Apply power and verify that the following functions are operative. Run all functions to be sure the control panel is fully operative.

• Indicator Lights
• Locking Features
• Jets
• Light
• Set Temperature

4. Locate the gasket in the kit.
5. Disconnect the panel and dry fit the gasket. Masking tape can be used to outline proper placement.
6. Remove the remaining backing from the gasket, and adhere the gasket to the bartop.
7. Place a 1/8¬ù bead of clear silicone to the lip area of the control panel.
8. Fit the panel onto the gasket and press down evenly to secure it in place.
9. Use the clean towel or rag to remove any excess silicone from the area.
10. Inform the spa owner to wait 24 hours before using the spa to allow the silicone to dry completely.