73293 Soothing 7 Jet Face Warm Grey

$76.67
In stock
SKU
73293
Add to Wish List
In stock

Add to wishlist

Soothing 7 Jet Face in warm grey used in Hot Spring Spas.

The Soothing Seven Jet is a larger jet with seven outlets. The seven outlets are designed to massage the tight muscles of the upper back and shoulders.

The intensity of the Soothing Seven Jet increases when more air is injected into the jet. Turning the faceplate can control the amount of air reaching an individual jet. To adjust the air, turn the faceplate clockwise to increase the air or counter-clockwise to decrease the air.

The Soothing Seven Jet consists of front and rear wallfitting, two o-rings, a gasket, and jet face (either white or gray).

73293 Soothing 7 Jet Face Warm Grey is for the following models:

Make Model Date Range
Hot Spring Grandee 2004-2005
Hot Spring Vista  2004-2005
Hot Spring Envoy 2004-2005
Hot Spring Vanguard 2004-2005
Hot Spring Jetsetter 2004-2005
Hot Spring Prodigy 2004-2005
Hot Spring Sovereign 2004-2005
Hot Spring Alccolade 2005
Hot Spring Highlife ILE 2003

 

 

Specifications

Item Description Part number
1 kit wall fitting 71362
2a Jet Face White 71366
2b Jet Face C Grey 71367
2c Jet Face W Grey 73293
2d Jet Face Taupe 72486
2e Jet face escutcheon c grey 73902
2e Jet face escutcheon w grey 73814
3 Gasket 36535
4 o ring 35986
5 Front Wall Fitting 36087
6 o-ring 36153
 
 
 
 
Removal
  1. Open or remove the spa cover.
  2. Remove the jet by grasping the jet faceplate and pulling it away from the spa shell.
  3. With jet in hand, two o-rings should be on the rear portion of the faceplate. If either o-ring is not present, inspect the inside of the front wallfitting and remove the missing o-ring.
  4. To reinstall the jet, reverse steps 1 to 3.
    Important: Make sure that the o-rings are properly seated.

 

Removal
  1. Open or remove the spa cover.
  2. Remove the jet by grasping the jet faceplate and pulling it away from the spa shell.
  3. With jet in hand, two o-rings should be on the rear portion of the faceplate. If either o-ring is not present, inspect the inside of the front wallfitting and remove the missing o-ring.
  4. To reinstall the jet, reverse steps 1 to 3.
    Important: Make sure that the o-rings are properly seated.
© 2023 Hot Tub Spa Supplies

|

eCommerce Design by DotcomWeavers