The spa light is visible through the light lens located in the bench seat of the spa. The light intensity and color sequence can be controlled on either the main control panel or auxiliary control panel.
Low voltage dimmable LED light, the light should never need replacing in normal use.
Disconnect power to the spa.
Access the equipment compartment.
Access the control box assembly.
Unplug the LED spa light power cord from the control box assembly (lower left-hand corner).
Unplug the LED data cable from the COMMUNICATION port of the control box.
IMPORTANT: When connecting the multicolored LED light, the LED power must connected before the LED data cable is connected. Reversing the order may cause permanent damage to the LED light board and the IQ2020 control box.
Locate the LED spa light assembly (on the equipment compartment wall).
Using pliers, remove the three x-mas tree fasteners from the LED light housing.
Remove the entire LED spa light assembly.
To reinstall LED spa light assembly, reverse steps 1 to 7.
72642 Kit, LED Light assembly is for the following models.