71367 Soothing 7 Jet Face, Cool Grey

$35.55
In stock
SKU
71367
Add to Wish List
In stock

Add to wishlist
71367 Soothing 7 Jet Face, Cool Grey
71367 Soothing 7 Jet Face, Cool Grey

The Soothing 7 Jet is a larger jet with seven outlets. The seven outlets are designed to massage the tight muscles of the upper back and shoulders.

The intensity of the Soothing 7 Jet increases when more air is injected into the jet. Turning the faceplate can control the amount of air reaching an individual jet. To adjust the air, turn the faceplate clockwise to increase the air, or counter-clockwise to decrease the air.

The Soothing 7 Jet consists of a front and rear wall fitting, two o-rings, a gasket, and a jet face (either white or gray).

71367 Soothing 7 Jet Face in Cool Grey is for the following models:

Make Model Date Range
Hot Spring Grandee 1997-2005
Hot Spring Vista 2004-2005
Hot Spring Envoy 2004-2005
Hot Spring Vanguard 2001-2005
Hot Spring Jetsetter 1997-2005
Hot Spring Prodigy 1997-2005
Hot Spring Sovereign 1997-2005
Hot Spring Classic 1997-2000
Hot Spring Landmark 1997-2003
Hot Spring Highlife ILE 2003

 

 

Specifications

l

Item Description Part number
1 kit wall fitting 71362
2a Jet Face White 71366
2b Jet Face C Grey 71367
2c Jet Face W Grey 73293
2d Jet Face Taupe 72486
2e Jet face escutcheon c grey 73902
2e Jet face escutcheon w grey 73814
3 Gasket 36535
4 o ring 35986
5 Front Wall Fitting 36087
6 o-ring 36153
 
 
 
 
Removal
  1. Open or remove the spa cover.
  2. Remove the jet by grasping the jet faceplate and pulling it away from the spa shell.
  3. With jet in hand, two o-rings should be on the rear portion of the faceplate. If either o-ring is not present, inspect the inside of the front wallfitting and remove the missing o-ring.
  4. To reinstall the jet, reverse steps 1 to 3.
    Important: Make sure that the o-rings are properly seated.

 

Removal
  1. Open or remove the spa cover.
  2. Remove the jet by grasping the jet faceplate and pulling it away from the spa shell.
  3. With jet in hand, two o-rings should be on the rear portion of the faceplate. If either o-ring is not present, inspect the inside of the front wallfitting and remove the missing o-ring.
  4. To reinstall the jet, reverse steps 1 to 3.
    Important: Make sure that the o-rings are properly seated.
© 2019 Hot Tub Spa Supplies

|

eCommerce Design by DotcomWeavers