36021 Program Jumper Shunt

SKU: 36021

$1.36

Program Jumper for IQ 2000, IQ2020 Control Boxes, and Interlock Timer Board

 

The Program Jumpers are used to configure the electronics in the spa to the specific spa model and year. For the spa to operate properly, it is important that the jumper terminals are installed in the proper locations.

Improperly placed program jumpers may cause the following;

  • Erratic functions.
  • Heat comes on with jets (house breaker trips on 115 volt spas).
  • Diagnostic LED flashes.
  • Premature failure off Tiger River light bulbs (in Tiger River spas with the IQ 2000 control box only).
Removal
  1. Disconnect power to the spa.
  2. Access the equipment compartment.
  3. Remove the control box.
  4. Locate the program jumpers on the electronic circuit board.
  5. Use needle nose pliers to remove and replace the jumpers as required.

 

 

 

 

Item Description Part #
1 Mechanical Timer 75049
2 10 Minute Timer 71346
3 Interlock/Timer Board 70821
4 .5 Fuse 34499
5 1.5 Fuse 34500
6 Jumper 36021
* Standoff 10 Minute Timer 70655
* Harness PCB 4T 115 5kw 32452

 

 

Item Description Part #
1 Kit CBA IQ2020 HSS 76082
2 Kit Control Head HSS '09 74959
3 Clamp Romex 3/4 30105
4 Plug Hole 0.875 36043
5 Bushing Strain Relief 3/8" 30099
6 Strain Releif 3/8" 7k-2 30098
7 Plug Hole 0.50" 36044
8 Thermostor Hi-Limit 39525
9 Thedrmostor Control 39530
10 Kit Heater Board Replacement 76071
11 Fuseholder 34506
12 Fuse 2 AMP 250V 34934
13 Program Jumper Shunt .100 36021
14 Kit 12C Comm HUB 8 Port 74150
15 Power Jumper 2 Pin 39192
16 Power Jumper 3 Pin 39193

 

 

 

 

Item Description Part #
1 Kit CBA Advent Orca Cal 76288
2 Kit Control Head Cal 76269
3 Clamp Romex 3/4" 30105
4 Plug Hole 0.875" 36043
5 Bushing Strain Releif 3/8" 30099
6a Kit Pump Cord 14/4 2SPD STRS 72461
6b Kit Pump Cord 14/3 1SPD STRS 72462
7 Strain Releif 3/8" 7k-2 30098
8 Cord Circ Pump 71434
9 Ozone Receptacle 72474
10 Thermistor Hi-Limit 72492
11 Thermistor Control 72493
12 Kit Heater Board Replacement 76071
13 Fuseholder 34506
14 Fuse 2 AMP 250V 34934
15 Program Jumper Shunt .100 36021
16 Kit 12C Comm Hub 8 Port 74150
17 Power Jumper 2 Pin 39192
18 Power Jumper 3 Pin 39193

 

 

Item Decsription Part #
1 Kit CBA Advent Cal 73181
2 Clamp Romex 3/4 30105
3 Plug Hole 0.3/8" 36043
4 Bushing Strain Relief 3/8" 30099
5a Cord Assy Pump 14/4 Flag 60" 72461
5b Cord Assy Pump 14/3 Flag 60" 72462
6 Strain Releif 3/8" 7K-2 30098
7 Cord Circ Pump Replacement 71434
8 Receptacle Assy Ozone 72474
9 Plug Hole 0.50" 36044
10 Thermostor Hi-Limit 72492
11 Thermistor Control 72493
* Kit Heater Board Replacemnet 74618
* Fuse Sloblo 1/2A 250V 5MM X 20MM 37089
* Program Jumper Sgunt .100 36021
* Kit Cable Assy Press Switch 72639
* Fuseholder 34506
* Fuse 2 Amp 250V 34934
* Kit 12C Comm Hub 8 Port 74150

 Item  Description  Part #
 1  MAIN BOARD  76998
 2  JUMPER, POWER 2-PIN T-BLOCK, JUMPER, POWER 3-PIN T-BLOCK  39192 & 39193
 3  HEATER RELAY BOARD  77118
 4  STRAIN RELIEF, METAL CLAMP  30105
 5  PLUG, 0.875" HOLE  36043
 6a  STRAIN RELIEF, SMALL CIRC PUMP  30098
 6b  STRAIN RELIEF, MEDIUM JET PUMP  30099
 7  PLUG, 0.5" HOLE  36044
 8  FUSE, 2A 250V SLO BLO  34934
 9  FUSE HOLDER, CONTROL BOX 60HZ  34506
 10  I2C COMM, 5-PORT  74150
 11  THERMISTOR ASSY CONTROL EBIC  39205
 12  THERMISTOR ASSY HI-LIMIT EBIC  39204
 13  JUMPER, PROGRAM 2-PIN  36021

 Item  Description  Part #
 1  CONTROL BOARD,ADVENT ORCA 60HZ  77656
 2  JUMPER, POWER 2-PIN T-BLOCK  39192
 3  JUMPER, POWER 3-PIN T-BLOCK  39193
 4  HEATER RELAY BOARD, ORCA 50/60  77118
 5  STRAIN RELIEF, METAL CLAMP  30105
 6  PLUG, 0.875" HOLE  36043
 7

 STRAIN RELIEF, SMALL CIRC PUMP

STRAIN RELIEF, MEDIUM JET PUMP

30098

30099 

 8  FUSE, 2A 250V SLO BLO  34934
 9  FUSE HOLDER, CONTROL BOX 60HZ  34506
 10  I2C COMM, 5-PORT  74150
 11  THERMISTOR, CONTROL BULLET  72493
 12  THERMISTOR, HI LIMIT ADVENT  72492
 13  JUMPER, PROGRAM 2-PIN  36021