This part holds the thermistor in place while providing a water tight seal around the thermistor. The fitting holds the thermistor so it will be in contact with the water in the spa.
- Locate the fitting in the upper portion of the spa sheer wall in the equipment compartmet above the jet pump.
- Make sure the water is below the fitting before loosening the fitting collar.
- Turn the keep nut at the end of the fitting counter clockwise and remove the thermistor.
- Turn the collar holding the fitting against the wall counter clockwise and pull through the water side.
- Replace in reverse order 4 to 1.
011075 Kit Sensor Fitting is for the following models:
| Make | Model | Date Range |
| Hot Spot | Sprint | 2010-2011 |
| Hot Spot | Dash | 2010-2011 |
| Caldera | Tahitian | 2002-2008 |
| Caldera | Niagara | 2002-2008 |
| Caldera | Geneva | 2002-2008 |
| Caldera | Cantabria | 2008-2009 |
| Caldera | Hawaiian | 2002-2010 |
| Caldera | Kauai | 2002-2015 |
| Caldera | Moorea | 2006-2010 |
| Caldera | Salina | 2010-2011 |
| Caldera | Makena | 2010-2013 |
| Caldera | Martinique | 2002-2010 |
| Caldera | Aspire | 2004-2008 |
| Caldera | Elation | 2003-2008 |
| Caldera | Cima | 2010-2011 |
| Caldera | Lina | 2010-2011 |
|
