This part is a replacement jet pump 1.5 HP 2 SPD for select Caldera hot tub models. Provides water pressure for the hydrotherapy system by recirculating water from the spa.
These pumps are designed for the presence of water at all times. Compatible with 2003 to current Caldera and Hot Spot spa models.
*Check specs section for full list of compatible models and years.
Remove the copper bonding wire from the bonding lug on the jet pump motor. Drain the pump by removing bleedline from the drain barbfitting or plug.
Turn the jet pump unions counterclockwise on the intake and discharge of the jet pump to disconnect them from the plumbing. Note: Make sure to save the union o-rings.
Remove the mounting bolt(s) securing the jet pump to the equipment compartment floor.
Remove the jet pump from the equipment compartment.
To reinstall the jet pump, reverse steps 1 to 9. Important: Make sure that the jet pump union o-rings are properly seated when re-tightening the unions.
