The store will not work correctly in the case when cookies are disabled.
JavaScript seems to be disabled in your browser.
For the best experience on our site, be sure to turn on Javascript in your browser.
30209 Hi-Limit Heater, 150 Deg.
Add to Wish List
Hi-Limit Heater, 150 Degrees
This part is a replacement hi-limit heater for select Hot Spring hot tub models. If the temperature of a heater exceed 150 degrees, this part will cut the power of the heater.
Located in the the spa heater equipment. This part is also referred to as the red "heater reset" button. Compatible with 1989 to 1994 Hot Spring Highlife spa models.
*Check specs section for full list of compatible models and years.
Specifications
Make
Model
Date Range
Hot Spring
Classic
1987-1994
Hot Spring
Grandee
1985-1994
Hot Spring
Prodigy
1984-1994
Hot Spring
Sovereign
1985-1994
Hot Spring
Jetsetter
1989-1994
Hot Spring
Highlife
1989-1994
WARNING: The heater high limit is a safety device and should never be tampered with or bypassed.
Disconnect power to the spa.
Access the equipment compartment.
Remove the high limit capillary bulb from the heater thermowell.
NOTE: Do not bend the capillary tube as that could cause miscalibration of the heater high-limit.
Access the control box.
Locate the heater high limit.
Remove the strain relief from around the capillary tube.
Slide the capillary tube out from the control box (use the slot in the control box).
Remove the two screws securing the high limit to the control box.
Remove the two wires from the high limit.
To reinstall the high limit, reverse steps 1 to 9.
© 2024 Hot Tub Spa Supplies
|
eCommerce Design by DotcomWeavers