The control panel consists of the knobs that spa owner uses to regulate the light and thermostat, as well as buttons to operate the jet pump(s). The control panel is attached to the spa by two screws.
*Check specs section for full list of compatible models and years.
NOTE: The thermostat control knob must be fully seated for the lock to engage.
NOTE: In early models, the light control knob must be turned all the way off to engage the lock. The locking of the light control knob was discontinued.
Removal
Unlock the control panel.
Turn the temperature and light knobs to the off position (counterclockwise).
Remove the two phillips head screws securing the control panel to the skirting.
Pull the control panel forward off the D-shaft drivers.
Remove the two D-shaft drivers.
CONTROL PANEL INSTALLATION
Place the D-shaft drivers onto the thermostat and light switch shafts.
Turn the both shafts to the off position (counterclockwise).
Ensure that the knobs of the control panel are still in the off position.
Install the control panel onto the D-shaft drivers.
Install the two phillips head screws securing the control panel to the skirting.
