The control panel consists of the buttons that spa owner uses to regulate the light and thermostat, as well as operate the jet pump(s). The control panel is attached to the spa by two screws. The control panel has a soft light to illuminate the control head display at night. This light cover protects the control panel's light and its components.
37248 Light Cover Control Panel is for the following models:
There are two locking features to the control panel, TEMPERATURE LOCK and SPA LOCK.
Spa Lock deactivates all functions of the control panel and is activated by pushing the LIGHT minus (-) and TEMP minus (-) at the same time and holding them down until the word SPA and the lock symbol are illuminated on the control panel display.
Temp Lock deactivates the temperature control function of the spa and is activated by pushing the LIGHT plus (+) and TEMP plus (+) at the same time and holding them down until the words SET TEMP and the lock symbol are illuminated on the control panel display.
Note: Unlock either system by reversing the corresponding process.
All spa models have an indicator light on the control panel. As well as being a power on indicator, the indicator light also serves as the signal light for the diagnostic feature incorporated in the Interlock/Timer circuit board. This light allows the homeowner to visually identify if a problem exists with the spa.
Steady light indicates spa is working properly.
No light indicates a problem with the source power source to the spa.
Flashing light indicates an open interlock circuit.
Gently pull the control panel away from the spa only far enough to thread the panel back through the cutout and into the equipment compartment. Caution: The fiber optic cables (if applicable) can be damaged or become dislodged by excessive pulling on the control panel.
Access the IQ 2000 control box.
Disconnect and remove the control panel ribbon cable (if applicable).
Separate the control head from the control panel.
To reinstall the control panel, reverse steps 1 to 7.