Remove the retainer ring and eyeball from the faceplate by unscrewing the retaining ring.
Remove the faceplate by grasping the faceplate on both sides and pulling straight out.
Remove the nozzle and nozzle retainer ring using the
Jetstream Nozzle tool.
JETSTREAM REPLACEMENT
Insert the nozzle and nozzle retainer ring. The nozzle elbow opening must be installed in the 12 o’clock position. Important: The 12 o’clock orientation refers to the direction the nozzle elbow opening is facing.
Once the nozzle and retainer ring are orientated and properly seated, use the Jetstream Nozzle tool to tighten the retainer ring. Important: The retainer ring must be properly secured.
Reinstall the faceplate by sliding it over the jet nozzle and pressing it into the jet body. Verify the nozzle is orientated properly by turning the handle 90 degrees in each direction from the initial orientation. The handle should turn a total of 180 degrees.
Reinstall the eyeball and eyeball retainer ring.
To verify the Jetstream is functioning properly, position the
Jetstream faceplate in the 12 o’clock position. When in this position, the Jetstream should be operative. If no water is flowing through the Jetstream, recheck the orientation of the nozzle.