SpaSlip. Instant gratification that will last for years. SpaSlip is made from a heavy-duty polyester and fabric laminate that’s pliable and amazingly durable. It’s fade resistant as well so it will beautify your backyard month-after-month. SpaSlip will extend the life of your expensive hard cover and it’s so energy efficient it may pay for itself over time. SpaSlips are available in four colors—gray, green, tan and black—and features two wind straps on opposing sides.
Our wind straps consist of woven nylon belts that are sewn into the skirt of the SpaSlip and secured by high-grade buckles requiring no additional mounting hardware. If your hot tub is exposed to high winds or you intend to seal it for long periods we recommend ordering a second set of wind straps.
Please allow 4-5 weeks for delivery.
It’s our goal to make sure that every Spa Slip fits properly - so we need you to take a few quick measurements before ordering.
For Square or Rectangular Spas: Using a tape measure, record the length (1) and width (2) of the thermal top covering your spa.
Next, measure the length of the skirt (3)—that is the distance from the top of the thermal cover to the bottom of the spa’s overhanging ledge.
Finally, check the radius of your spa’s corner (4). To do this, place a straight edge along the side of the tub and measure the distance from the end of the arc of the radius to the point in space that would represent a 90° right angle. (In the illustration to the right, the Radius=6”.)
For Round Spas: Using a tape measure, record the diameter (1) of the thermal top covering your spa. Next, measure the length of the skirt (2)—that is the distance from the top of the thermal cover to the bottom of the spa’s overhanging ledge.
**PLEASE NOTE** The skirt length includes both the foam section of the spa cover and the loose hanging section. This should equal out to be approximately 9 inches on a typical spa.