70811 Jetstream Adjustable Body

Name: 70811 Jetstream Adjustable Body
Brand: Watkins
SKU: 70811
Price: 38.26 USD
Availability: InStock

$38.26

In stock

SKU

70811

Add to Wish List

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Description

Jetstream Adjustable Body used in1994-1997 Hot Spring and Tiger River Spa Models

The Adjustable Jetsteam is a powerful jet that combines the pressure of several jets into a substantial stream. The Adjustable Jetstream is located in the footwell of the spa to provide a massage to the feet and calves. Additionally, turning the Adjustable Jetstream Jet will activate the various jet modes of the spa.

The air control valve is used to control the intensity of the Jetstream. To adjust the intensity, turn the air control lever clockwise to increase the intensity (air) or counter-clockwise to decrease the intensity (air).

Specifications

Refer to the following items that can diminish the flow from the Adjustable Jetstream Jet;

Jetstream Jet partially closed
Dirty or clogged filters
Low water level
Jet pump malfunctioning
Diverter valve improperly positioned
In-foam check valve problem

Specifications:

(back to top)

Removal

Remove the retainer ring and eyeball from the faceplate by unscrewing the retaining ring.
Remove the faceplate by grasping the faceplate on both sides and pulling straight out.
Remove the nozzle and nozzle retainer ring using the Jetstream Nozzle tool.

JETSTREAM REPLACEMENT

Insert the nozzle and nozzle retainer ring. The nozzle elbow opening must be installed in the 12 o‚Äö√Ñ√¥clock position.
Important: The 12 o‚Äö√Ñ√¥clock orientation refers to the direction the nozzle elbow opening is facing.
Once the nozzle and retainer ring are orientated and properly seated, use the Jetstream Nozzle tool to tighten the retainer ring.
Important: The retainer ring must be properly secured.
Reinstall the faceplate by sliding it over the jet nozzle and pressing it into the jet body. Verify the nozzle is orientated properly by turning the handle 90 degrees in each direction from the initial orientation. The handle should turn a total of 180 degrees.
Reinstall the eyeball and eyeball retainer ring.
To verify the Jetstream is functioning properly, position the Jetstream faceplate in the 12 o‚Äö√Ñ√¥clock position. When in this position, the Jetstream should be operative. If no water is flowing through the Jetstream, recheck the orientation of the nozzle.

Questions